Evaporator
Evaporating
Since 14:32 · 2h 14m
Scrubber
Washing
Since 13:55 · 2h 51m
Active Alerts2 active
Evaporator pH out of range
Washer dry bobber triggered
Last batch completed
Today at 11:05
Evaporator Timer
00:21:47
EvaporatorTime
Duration
60:00
Scrubber Timer
00:08:12
WasherFill
Duration
60:00
Sensor Readings tap to analyse
Evaporator pH
9.4pH
↓ 0.3 in 10 min
Washer pH
6.8pH
→ stable
Flow Rate
342l/h
→ stable
Commands
Evaporator
Buffer Silo
Evaporator pH — Trend
pH value
Alert threshold (9.0)
Alert triggered
Analyse tab is available to Dealer role only. Switch role to explore this view.
Multi-sensor overlay
Select sensors from the list →
No sensors selected.
Add one from the list to start.
Add one from the list to start.
Active
Evaporator pH out of range
Washer dry bobber triggered
History
Evaporator fill valve timeout
Resolved 08:31
Buffer silo too full
Resolved 16:52
Safety ventilator fault
Resolved 09:15
Washer empty valve stuck open
Resolved
Settings are read-only for the Farmer role. Contact your dealer to make changes.
Buffer Silo
Fill time
How long the buffer silo fill valve stays open per fill cycle
Filter time
Duration of the microfilter cycle before the silo is released
Empty time
Maximum time allowed for the buffer silo to empty
Evaporator
Process time
Total duration of one evaporator batch cycle
Fill time
Maximum time allowed to fill the evaporator before triggering an alert
Lag fill time
Extra wait time after the fill valve closes before the process continues
Leach pump on time
How long the leach pump runs per pulse during the evaporation phase
Leach pump off time
Rest interval between leach pump pulses
Leach pump pulses
Number of leach pump cycles per batch before requiring a counter reset
Start pH
Minimum pH required in the evaporator before the process will start
Spray interval
How often the spray valve activates during evaporation
Blend interval
How often the blend cycle runs to homogenise the liquid
Empty time
Maximum time allowed for the evaporator to empty before triggering an alert
Lag empty time
Extra wait after the empty valve closes before the next state begins
Washer
Empty pH
Target pH level that indicates the washer is sufficiently empty
Empty EC
Target conductivity level that confirms the washer liquid is spent
Max pH
Maximum permissible pH in the washer — exceeded values trigger acid dosing
Acid pump pulses
Number of acid pump cycles per wash before requiring a counter reset
Acid pump on time
How long the acid pump runs per dosing pulse
Acid pump off time
Rest interval between acid pump pulses
Empty time
Maximum time allowed for the washer to empty before triggering an alert
Wait empty time
Settling delay after emptying before the washer accepts a new fill
Evaporator pH error
Evaporator pH exceeded configured threshold of 9.0 pH
Today 14:18
Washer dry bobber triggered
WasherDryBobber alert triggered in Washer subsystem
Today 13:27
Process started
Gazoo started a new batch process
Today 12:18
Evaporator fill valve timeout resolved
Alert resolved after 17 minutes
Today 08:31
Batch completed
Batch 47 completed successfully
Today 11:05
Gazoo is back online
Device reconnected after 4 minutes offline
Yesterday 16:42
Gazoo has not been seen for 15 min
Device may be offline — no heartbeat received
Yesterday 16:27